Toshiba V Series - Page 35

6F8C0878 21
3.2 Network Parameter Setting
3
IP address setting
Set network parameters by the kink of IP address used. Setting procedures are as
follows.
Start
Single network is
used.
Free IP address
is used.
Refer to IP address free
setting.
N
Y
N
Y
Use default IP address of
EN module.
Go to
①
Integrated controller
standard setting is
used.
Y
N
Refer to class B (integrated
controller standard setting).
Refer to TOSDIC-
CIE
1200 setting.
Use dual network.
①
Free IP address
is used.
Refer arbitrary setting.
N
Y
Use default IP address of
EN module.
Integrated controller
standard setting is
used.
Y
N
Refer to class B (integrated
controller standard setting).
Refer to TOSDIC-
CIE
1200 setting.