32 model 3000 Ethernet Module / DS Connection Module Operation Manual
Chapter 3 Setting
3
(14)After registering the above, confirm that the network information of the corresponding
Ethernet module can be read from the serial communication port (TOOL).
Start the configuration editor [Hardware configuration] for controller A to open the
screen which shows the registered hardware configuration for controller A. Then
select EN741 and execute [Edit (E)] [Parameter setting (P)] to open the following
screen.
(15)When [Tool and Card] is clicked, the network information that the Ethernet module
has is displayed from the serial communication port (TOOL).
To Next Page
Loading...
