Disassembly and Reassembly
Toshiba
4-19
1-2-29 How to Eject the Cassette Tape
(If the unit does not operate on condition that is
inserted into housing ass’y)
1) Turn the Gear worm Πclockwise with screw
driver.(Refer to arrow)
(Other method : Remove the Screw of Motor Load
Ass'y, Separate the Motor Load Ass'y)
Fig. 4-39
Fig. 4-40
2) When Slider S,T are approched in the position of
unloading, rotate holder Clutch counterclockwise
after inserting screw driver in the hole of frame's
bottom in order to wind the unwinded tape.
(Refer to Fig.4-40)
(If you rotate Gear Worm Πcontinuously when
tape is in state of unwinding, you may cause a
tape contamination by grease and tape damage.
Be sure to wind the unwinded tape in the state of
set horizently.)
3) Rotate Gear Worm Πclockwise using screw driver
again up to the state of eject mode and then pick
out the tape.(Refer to Fig.4-39)
FRAME
1-2-27 Post #8 Guide Ass’y Removal
1) Rotate the Post #8 Guide Ass’y Œ in the direction
of arrow to lift up.
ΠPOST #8 GUIDE ASS'Y
Fig. 4-37 Post #8 Guide Ass’y Removal
1-2-28 Level Head Cleaner Ass’y Removal
(Optional)
1) Release the Hook Œ.
2) Lift the Lever Head Cleaner Ass’y
´.
ΠHOOK
´ LEVER HEAD CLEANER ASS'Y
SLEEVE-HEAD CLEANER
Fig. 4-38 Post #8 Guide Ass’y Removal
To Next Page
Loading...
