Toshiba W-603 - Important Precautions

Toshiba
I
SERVICE GUIDE
Assy Cylinder, the Capsrtan Motor & TM-Block are used for this model, as shown below.
Assy-Cylinder
How to identify the Assy-Cylinder
ALPS Cylinder SEM Cylinder
CONNECTOR ; Pin 7 or Pin 5
CONNECTOR ; Pin 5
Fig. 1
1) Three kinds of the Assy-Cylinder as shown below.
Œ ALPS Cylinder ´ SEM Cylinder
Connector ; Pin 7 Connector ; Pin 5
Connector ; Pin 5
2) When replacing the Assy-Cylinder, be sure to replace only “SEM Cylinder”.
The only part-no of “SEM Cylinder” is shown in the “CH7. Replacement Parts List” of Service Manual.
3) When changing from ALPS (connector ; pin 7) cylinder to SEM (connector ; pin 5) cylinder.
- Change CN605 (Connector ; pin 7 pin 5)
- Change CN605B (Cable-Flat ; pin 7 pin 5)
4) After replacing the “SEM Cylinder”, use type “C, D, G, H” optional for “NVRAM Option Setting”. (See page 5-9)
The Maker of Assy Cylinder
1
2
ALPS
SEM
The Maker of Assy Capstan Motor
1
2
SANKYO
SEM
Two kinds of TM-Block
1
2
SIF available
Not SIF availablea