5-8
Toshiba
Alignment and Adjustment
5-2-3 Reel Torque
1) The rotation of the capstan motor causes the
holder clutch ass’y to rotat through the belt pulley.
2) The spring wrap PLAY/REV of holder clutch ass’y
drives the disk reel S, T through gear idle by rota-
tion of gear center ass’y.
3) Brake is operated by slider cam at FF/REW mode.
4) Transportation of accurate driving force is done by
gears. (Gear Center Ass’y)
Note : If the spec. does not meet the followings speci-
fications, replace the holder clutch ass’y and then
recheck.
4) As rotating Disk S Reel Πclockwise and the
region of adjusting in the Main Base (in shape of
slit) clockwise or counterclockwise after inserting
screw driver in the slit on Main Base. Adjust the
left end edge of Lever Tension Ass’y ˇ to 1.3
+1.5/-0.5mm from the location of mark in the
Main Base.
5) As rotating Disk S Reel Œ, double-check the loca-
tion of the left end edge of Lever Tension Ass’y
and the quanity of crossing from mark on Main
Base. (+1.0/-0.5mm)
Counterclockwise : Torque UP
Clockwise : Torque DOWN
Back Tension should be 56 ± 15g.cm at inspecting it
with Back Tension Meter.
Fig. 5-16 Tension Pole and Back Tension Adjustment
5-2-4 Location adjustment and Confirmation of
Tension Post
1) Remove the holder cassette ass’y and then push
the lever FL Arm-R to the direction of loading.
2) Push the lever tension drive Πin the direction of
arrow. (See Fig. 5-14)
3) Turn the gear worm wheel ´ clockwise so that
“Timing Point” of the slider FL drive ˇ and gear
FL cam ¨ can be aligned (See Fig. 5-14)
Fig. 5-14
Fig. 5-15
<Table 5-1>
Note :
1) Mark on Main Base is located in about 1.3mm
from inside of bending line.
2) Be careful not to deform the region of adjusting on
Main Base up and down at adjusting.
MODE TORQUE g/cm GAUGE
PB
NTSC 82.5 ± 27.5
Cassette Torquemeter
PAL 79 ±27
RPS 145 ± 30 Cassette Torquemeter
To Next Page
Loading...
