Fig. 1-6-7 FL drive slider
13.When mounting the FL cam gear (7), align the mark
of the FL cam gear (7) with the center of the worm
wheel (9).
Fig. 1-6-8 Joint Gear 1
Apply grease to the
shaded portion .
Apply grease to the
shaded portion .
Fig. 1-6-9 FL cam gear
12.When mounting the joint gear 1 (8), mount it so that
the cutout portion of the gear is faced with the
direction of the FL cam gear (7).
Two holes (Super-V DASH)
Apply grease to the
shaded portion .
Fig. 1-6-10
Joint gear 1 (8)
Cutout portion
FL cam gear (7)
Worm wheel (9)
Mark
Joint gear 1 (8)
Joint gear 2 (6)
Cam slider (10)
Align marks.
Align marks.
Fig. 1-6-11
14.When mounting the joint gear 2 (6), align the mark of
the joint gear (8) with the mark of the cam slider (10).
Fig. 1-6-12
15.Mount each part in the reverse order of removal.
To Next Page
Loading...
