Real-Time Clock
Problem Procedure
The BIOS setting
and system date/
time are lost.
The lasting time of the Real-Time Clock (RTC) has
run out. You must set the date and time in the
BIOS setup utility by using the following steps:
1. Launch the BIOS setup utility.
Refer to the TOSHIBA Setup Utility section for
further information.
2. Set the date in the System Date field.
3. Set the time in the System Time field.
4. Select Save and Exit -> Exit Saving
Changes- a confirmation message will be
displayed.
5. Select Yes - the BIOS setup utility will end
and the computer will restart.
Display screen
Apparent problems of the computer's display panel might be related to
setup and configuration of the computer.
Problem Procedure
No display Change the display priority and ensure that it is not
set for the external display only.
Markings appear on
the computer's
display screen.
These marks might have come from contact with
the screen. Try to remove the marks by gently
wiping the display screen with a clean dry cloth or,
if this fails, with a good quality LCD screen cleaner.
In this latter instance, you should always follow the
instructions with the screen cleaner and always
ensure that you let the display screen dry properly.
User's Manual 6-6
To Next Page
Loading...
