Total TH215456 - Tool Operation and Accessory Management; Accessory Installation and Removal; Auxiliary Handle Adjustment Guide; Switch Operation and Safety Cautions

3
A* Install-Remove Accessories
Caution:
2
By installing and removing accessories,
please make sure that the tool is OFF,
and the cord should not be plugged in.
Pull out the bolt (1) and swivel it to make
the flange towards the direction of motor
housing.
1
Insert accessory into the tool holder
through the dust shield, while twisting
and pushing inward until it locks
automatically into place.
B
*
* Auxiliary Handle
The tool must be supported with the
auxiliary handle (1), which can be
1
swiveled 360
o
. To reposition and/or
swivel the handle, loosen the hand
3
grip (2), move the handle to the
2
desired position along the barrel (3)
and securely retighten the hand grip.
C
C
*
* Switch Operation
If you want to operate the tool, you
only need to press the switch (1).If
you want to operate the tool non-stop,
you can switch and press the locking
button (2). If you want to stop the tool,
press the switch again and release
Caution :
1. Please check if the switch is OFF
when plug in
2. Do not use adhesive tape or rope
to fix the switch on OFF state.