MODE
OVERRIDE
Advanced Setup
Page 16
Adjust the minimum
allowable cool setpoint
when security is in effect.
(Step 19 only appears
if step 17 is not 0).
(35 - 99)
Press
Press the Mode button.
While holding the Mode, press the Override
button for 2 seconds to leave the Setup
screens. If no buttons are pressed, the
display will leave the setup screens after
30 seconds.
Step # Description Range Factory Default
1 Time of day clock set 24 hour 12:00 Am
2 Day of the week Sun - Sat Monday
3 Fan operation Auto / On Auto
4 Heat Pump Off / On Off
5 Reversing Valve polarity O / B O
6 Electric Heat Off / On Off
7 Deadband or Temperature swing 1 - 6 2
8 Forced minimum difference heat/cool 0 - 6 2
9 Cycles per hour d, d1, 2 - 6 6
10 Fan Purge timer 0:00 - 3:00 0:00
11 Thermoglow backlight Off / On On
12 Reset Service Filter icon - - - -
13 Service Filter run time set 0 -1950 500
14 Soft Start 0 - 99 0
15 Fahrenheit or Centigrade F / C F
Advanced Setup Table
17 Security Levels 0 - 3 0
18 Maximum allowable Heat setpoint 35 - 99 80
19 Minimum allowable Cool setpoint 35 - 99 65
16 Outside/Duct Sensor Yes / No No
65
i9
COOL
Locked
Setup
lo
To Next Page
Loading...
