94
If you pushed any wrong buttons,
“Err” and the number of errors you
have made will appear on the display
before “SEC” does. Go back to step 2
and try again. If the display returns to
“- - -” while you are entering the code,
go back to step 3.
To make sure the security code has been
accepted, turn the ignition to “LOCK” and
then back to “ACC”. “SEC” should appear
on the display.
NOTICE
A tenth error will activate the
anti-theft system and “HELP” will
appear on the display. The audio
system will be completely
inoperable. At this time, the
anti-theft light also comes on. If this
occurs, contact your Toyota dealer.
Clearing the security code
1. Turn off the audio system.
Turn the ignition key to “ACC”.
Simultaneously push and hold in “1”, “6”,
and “PWR/VOL” until “SEC” appears on
the display.
2. While you are holding in the “∧” side of
“TUNE”, push “1”.
The display will read “- - -”.
On some models, “” and “” will also
turn on.
To Next Page
Loading...
