201
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
Halogen bulbs have pressurized
gas inside and require special
handling. They can burst or shatter
if scratched or dropped. Hold a bulb
only by its plastic or metal case. Do
not touch the glass part of a bulb
with bare hands.
CAUTION
!
NOTICE
Only use a bulb of the listed type.
Light bulbs Bulb
No.
W Type
Headlight
(low beam)
9006 55 A
Headlight
(high beam)
9005 65 B
Parking lights 168 5 D
Front turn signal lights 1156 27 C
Front side marker
lights
194 3.8 D
Rear turn signal ligths 1156 27 C
Stop and tail lights 1157 27/8 C
Back-up lights 1156 27 C
License plate light 168 5 D
High mounted stop
light
921 18 D
Interior light — 8 E
Front personal light — 8 C
Rear personal light — 8 C
Glovebox light — 1.2 D
Door courtesy lights 194 5 D
Trunk light — 3 E
A: HB4 halogen bulbs
B: HB3 halogen bulbs
C: Single end bulbs
D: Wedge base bulbs
E: Double end bulbs
1. Unplug the connector while de-
pressing the lock release
If the connector is tight, wiggle it.
—HeadlightsReplacing light bulbs—
To Next Page
Loading...
