Toyota 2001-2004 Corolla - REMOVE TIMING GEAR COVER OIL SEAL; INSTALL TIMING GEAR COVER OIL SEAL

A62183
Cut Position
Pry
A62184
A62837
SST
A64005
–ENGINE MECHANICAL TIMING CHAIN OR BELT COVER OIL SEAL
14–129
2004 COROLLA (RM1037U)
6. REMOVE TIMING GEAR COVER OIL SEAL
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver with taping its tip, pry out the oil seal.
NOTICE:
After the removal, check if the crankshaft is not damaged.
If there is, mend it with a sandpaper (#400).
7. INSTALL TIMING GEAR COVER OIL SEAL
(a) Apply MP grease to a new oil seal lip.
NOTICE:
Keep the lip off foreign materials.
(b) Using SST, tap in the oil seal until its surface is flush with
the timing chain cover edge.
SST 09223–22010
NOTICE:
Wipe off extra grease on the crankshaft.
8. INSTALL CRANKSHAFT PULLEY
(a) Align the pulley set key with the key groove of the pulley,
and slide on the pulley.
(b) Using SST, install the crankshaft pulley bolt.
SST 09960–10010 (09962–01000, 09963–01000)
Torque: 138 N⋅ m (1,407 kgf⋅cm, 102 ft⋅ lbf)
9. INSTALL ENGINE MOUNTING INSULATOR
SUB–ASSY RH
(a) Install the engine mounting insulator RH with the 4 bolts
and 2 nuts.
Torque: 52 N⋅ m (530 kgf⋅cm, 38 ft⋅lbf)
10. INSTALL FRONT WHEEL RH
Torque: 103 N⋅ m (1050 kgf⋅cm, 76 ft⋅lbf)
11. CHECK ENGINE OIL LEAK