A60622
A01045
A64005
A11858
A62186
Paint Mark
14–8
–ENGINE MECHANICAL VALVE CLEARANCE
2004 COROLLA (RM1037U)
10. REMOVE FAN AND GENERATOR V BELT
(a) Turn the V–ribbed belt tensioner slowly clockwise and
loosen it. Then, remove the fan and generator V belt and
put back the V–ribbed belt tensioner little by little and fix
it quietly.
11. REMOVE ENGINE MOUNTING INSULATOR
SUB–ASSY RH
(a) Remove the PS oil pump reservoir and put it aside.
(b) Place a wooden block between the jack and engine, and
set the jack, then remove the 4 bolts, the 2 nuts and en-
gine mounting insulator RH.
12. REMOVE V–RIBBED BELT TENSIONER ASSY
(a) Remove the bolt, nut and V–ribbed belt tensioner.
HINT:
Handle a jack up and down to remove the bolt.
13. ADJUST VALVE CLEARANCE
NOTICE:
Be sure not to revolve the crankshaft without the chain ten-
sioner.
(a) Set the No. 1 cylinder to the TDC/compression.
(b) Place match marks on the timing chain and camshaft tim-
ing sprockets.
To Next Page
Loading...
