’02 4Runner_U (L/O 0108)
280
2002 MY 4RUNNER_U (OM35787U)
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent yourself from burning,
do not replace the light bulbs while
they are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.
Light bulbs
Bulb
No.
W Type
Headlights — 60/55 A
Front fog lights — 55 B
Parking and front
side marker lights
— 5 C
Front turn signal
lights
— 21 C
Rear turn signal
lights
— 21 D
Stop/tail lights — 21/5 C
Back–up lights — 18 C
License plate lights — 5 C
High mounted
stoplight
921 18 C
Interior light — 8 E
Personal lights — 8 E
Glove box light — 1.4 C
Luggage
compartment light
— 8 E
A: HB2 halogen bulbs
B: H3 halogen bulbs
C: Wedge base bulbs (clear)
D: Wedge base bulbs (amber)
E: Double end bulbs
Replacing light bulbs—
To Next Page
Loading...
