Toyota 2002 4runner - Page 54

’02 4Runner_U (L/O 0108)
240
2002 MY 4RUNNER_U (OM35787U)
1. Use a Phillips–head screwdriver and
remove the clip.
2. Unhook the towing hook cover.
 Before emergency towing, check that
the hook is not broken or damaged and
that the installation bolts are not loose.
 Fasten the towing cable or chain se-
curely to the hook.
 Do not jerk the hook. Apply steady and
even force.
 To avoid damaging the hook, do not
pull from the side or at a vertical
angle. Always pull straight ahead.
CAUTION
If the emergency towing hook is used
to get out when your vehicle becomes
struck in mud, sand or other condi-
tion from which the vehicle cannot be
driven out under its own power, make
sure to observe the precautions men-
tioned below. Otherwise, excessive
stress will be put on the hook and
the towing cable or chain may break,
causing serious injury or damage.
 If the towing vehicle can hardly
move, do not forcibly continue the
towing. Contact your Toyota dealer
or a commercial tow truck service
for assistance.
 Tow the vehicle as straight ahead
as possible.
 Keep away from the vehicle during
towing.
—Emergency towing hook
precautions