’02 AVALON U (L/O 0107)
158
2002 MY AVALON_U (OM22493U)
AM
Push “AM” to turn on the radio and select
the AM band. “AM” will appear on the
display.
If the audio system is off, you can turn
on the radio by pushing “AM”. Also, push
“AM” to switch from cassette or compact
disc operation to AM.
AUDIO CTRL / MODE (Audio control
and mode adjustment)
Each time you push the AUDIO CONTROL
knob, the mode changes. To adjust the
tone and balance, turn the knob.
BASS: Adjusts low−pitched tones. The dis-
play ranges from −5 to 5.
MID: Adjusts mid−pitched tones. The dis-
play ranges from −5 to 5.
TREBLE: Adjusts high−pitched tones. The
display ranges from −5 to 5.
BALANCE: Adjusts the sound balance be-
tween the right and left speakers. The
display ranges from −7 to 7.
FADER: Adjusts the sound balance be-
tween the front and rear speakers. The
display ranges from −7 to 7.
CD (Compact Disc)
Push “CD” while in radio or cassette
mode to switch to compact disc mode. If
the audio system is off, pressing “CD” will
turn on the compact disc player. A disc
must be loaded in the player.
When the audio is set into compact disc
operation, the display shows the track or,
track and disc number currently being
played.
If the player or another unit equipped with
the player malfunctions, your audio system
will display one of the six following error
messages.
Error codes
“WAIT”: The compact disc player unit may
be too hot due to temperature. Allow the
player to cool down.
“ERR 1”: The disc may be dirty, damaged
or inserted incorrectly (up−side down).
Clean disc and re−insert.
“ERR 2”: The compact disc player is
empty. Load disc and re−try.
“ERR 3” or “ERR 4”: This indicates inter-
nal error. Re−load discs.
“OPEn”: The compact disc auto changer
lid is open. Close the compact disc auto
changer lid.
If the malfunction still exists, take your
vehicle to your Toyota dealer.
DISC
By using this button, you can select a
disc you wish to listen to.
Push either side of the button until the
number of the disc you want to listen
appears on the display.
Dolbyr
B NR
∗
If you are listening to a tape that was
recorded with Dolbyr B Noise Reduction,
push the button marked with the double−D
symbol. The double−D symbol will appear
on the display. Push the button again to
turn off Dolbyr B NR.
The Dolby NR mode reduces tape noise
by about 10 dB. For best sound reproduc-
tion, play your tapes with this button on
or off according to the mode used for
recording the tape.
∗
: Dolby noise reduction manufactured under license from
Dolby Laboratories Licensing Corporation. “DOLBY” and the
double D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
To Next Page
Loading...
