Toyota 2002 Camry - Page 1004

45
B50564
B51963
B56863
Protrusion
Protrusion
Front
61–16
–SEAT BELT REAR SEAT BELT (TMC MADE)
2466Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
14. INSTALL REAR SEAT INNER W/CENTER BELT ASSY
LH
(a) Check the degree of tilt when the belt begins to lock the
ELR.
(1) Check the belt will not lock within 15 degrees of tilt
in all the direction but the belt will lock over 45 de-
grees of tilt when moving the installed retractor
gently.
(b) Install the retractor with the bolt.
Torque: 42 N⋅m (420 kgf⋅cm, 31 ft⋅lbf)
(c) Check the ELR lock.
(1) Check that the belt will lock when pulling out the belt
quickly with the belt installed.
(d) Check the fastening function for child restraint system.
NOTICE:
Check should be done with the assembly installed.
(1) Check that the belt cannot be pulled out any more
but can be rewound after the belt is fully pulled out.
(2) Check that the belt can be pulled out and rewound
after the belt is fully rewound.
(e) Install the floor anchor with the bolt, directing an arrow
mark on the plate to the vehicle’s front direction.
Torque: 42 N⋅m (420 kgf⋅cm, 31 ft⋅lbf)
NOTICE:
Take care for the anchor not to run onto the protrusion part
of the floor panel.
(f) Check the ELR lock.
(1) Check that the belt will lock when pulling out the belt
quickly with the belt installed.