Toyota 2002 Camry - Page 1010

650BK–01
E57951
E57879
GND
SW1
–LIGHTING LIGHTING SYSTEM
65–3
2472Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
INSPECTION
1. HEADLAMP DIMMER SWITCH ASSY
(a) Inspect light control switch continuity.
(1) Check that there is continuity between terminals at
each switch position as shown in the chart.
Switch operation Tester connection Specified condition
OFF – No continuity
TAIL 14 – 16 Continuity
HEAD 13 – 16 – 14 Continuity
(b) Inspect headlamp dimmer switch continuity.
(1) Check that there is continuity between terminals at
each switch position as shown in the chart.
Switch operation Tester connection Specified condition
FLASH 7 –8 – 16 Continuity
LOW BEAM 16 – 17 Continuity
HI BEAM 7 – 16 Continuity
(c) Inspect turn signal switch continuity.
(1) Check that there is continuity between terminals at
each switch position as shown in the chart.
Switch operation Tester connection Specified condition
Right turn 2 – 3 Continuity
Neutral – No continuity
Left turn 1 – 2 Continuity
(d) Inspect front fog light switch continuity.
(1) Check that there is continuity between terminals at
each switch position as shown in the chart.
Switch operation Tester connection Specified condition
OFF – No continuity
ON 10 – 11 Continuity
2. HEATER CONTROL HOUSING SUB–ASSY
(a) Auto A/C:
Inspect hazard warning signal switch.
Switch operation Tester connection Specified condition
OFF 1 – 34 No continuity
ON 1 – 34 Continuity