Toyota 2002 Camry - Instrument Panel Passenger Airbag Assembly

D26599
Example:
CORRECT
WRONG
Z13950
Example:
D26600
Example:
CORRECT
WRONG
–INTRODUCTION REPAIR INSTRUCTION
01–11
11Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(6) When disposing of the vehicle or the horn button assembly alone, the airbag should be deployed
using an SST before disposal (See page 60–17).
Perform the operation in a safe place away from electrical noise.
(d) INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
(1) Always store a removed or new instrument panel passenger airbag assembly with the airbag
inflation direction facing upward. Placing the airbag assembly with the airbag inflation direction
facing downward could cause a serious accident if the airbag inflates.
(2) Never measure the resistance of the airbag squib (This may cause the airbag to inflate, which
is very dangerous).
(3) Grease should not be applied to the instrument panel passenger airbag assembly, and the airbag
door should not be cleaned with detergents of any kind.
(4) Store the airbag assembly where the ambient temperature remains below 93°C (200°F), without
high humidity and away from electrical noise.
(5) When using electric welding, first disconnect the airbag connector (2 yellow pins) installed on the
assembly before starting work.
(6) When disposing of a vehicle or the airbag assembly alone, the airbag should be deployed using
an SST before disposal (See page 60–34).
Perform the operation in a safe place away from electrical noise.