Toyota 2002 Camry - Engine Mechanical Service Data

030ET–01
03–12
–SERVICE SPECIFICATIONS ENGINE MECHANICAL
123Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
ENGINE MECHANICAL
SERVICE DATA
2AZ–FE
Battery specific gravity at 20C (68F) 1.25 1.29
Ignition timing w/ Terminals TC and CG of DLC3 connected
w/ Terminals TC and CG of DLC3 disconnected
8 – 12 BTDC
5 – 15 BTDC
Idle speed A/T
M/T
610 – 710 r/min.
650 – 750 r/min.
Compression
Compression pressure
Minimum pressure
Difference between each cylinder
1.360 MPa (13.9 kgf/cm
2
, 198 psi)
0.98 MPa (10 kgf/cm
2
, 142 psi)
100 kPa (1.0 kgf/cm
2
, 14 psi)
Balance shaft
Thrust clearance Standard
Maximum
Oil clearance Standard
Maximum
Housing journal bore diameter Mark 1
Mark 2
Mark 3
Journal diameter
Bearing center wall thickness Mark 1
Mark 2
Mark 3
0.050 – 0.090 mm (0.0020 – 0.0035 in.)
0.090 mm (0.0035 in.)
0.004 – 0.031 mm (0.0002 – 0.0012 in.)
0.031 mm (0.0012 in.)
26.000 – 26.006 mm (1.0236 –1.0239 in.)
26.007 – 26.012 mm (1.0239 –1.0241 in.)
26.013 – 26.018 mm (1.0241 –1.0243 in.)
22.985 – 23.000 mm (0.9049 – 0.9055 in.)
1.486 – 1.489 mm (0.0585 – 0.0586 in)
1.489 – 1.492 mm (0.0586 – 0.0587 in)
1.492 – 1.495 mm (0.0587 – 0.0589 in)
Oil pump drive gear
Gear diameter (w/chain) Minimum 48.2 mm (1.898 in.)
Oil pump drive shaft gear
Gear diameter (w/chain) Minimum 48.2 mm (1.898 in.)
Crankshaft timing gear or sprocket
Gear diameter (w/chain) Minimum 51.6 mm (2.031 in.)
Chain tensioner slipper
Wear Maximum 1.0 mm (0.039 in.)
Chain vibration damper No.1
Wear Maximum 1.0 mm (0.039 in.)
Cylinder head set bolt
Bolt length Standard
Maximum
161.3 – 162.7 mm (6.350 – 6.406 in.)
164.2 mm (6.465 in.)
Chain sub–assy
Elongation Maximum 115.4 mm (4.543 in.)
Camshaft timing gear or sprocket
Sprocket diameter (w/chain) Minimum 97.3 mm (3.831 in.)