Toyota 2002 Camry - Page 1230

B56615
Tape
75–12
–ENGINE HOOD/DOOR FRONT DOOR
2692Author: Date:
2002 CAMRY REPAIR MANUAL 185W (RM881U)
(5) Assemble the power window regulator and door glass.
HINT:
Never rotate the motor to the down direction until the installation of the window glass is completed.
25. INSTALL FRONT DOOR WINDOW REGULATOR SUB–ASSY LH
(a) Install the temporarily installed bolt securely.
(b) Install the temporarily installed bolt to the window regulator to the front door panel, and install the front
door window regulator temporarily.
(c) Tighten the 5 bolts and the temporarily installed bolt.
(d) Disconnect the connector.
26. INSTALL FRONT DOOR GLASS SUB–ASSY LH
(a) Install the front door glass with the 2 bolts.
HINT:
When the installation point of the front door glass does not match, adjust the regulator position by manual
operation.
(1) Connect the power window switch to the wire harness and turn the ignition switch ON.
(2) Repeat UP and DOWN operation several times manually.
(3) Check if AUTO UP →AUTO DOWN operates in the automatic operation.
HINT:
 Note that the jam protection function does not operate just after resetting.
 Reset the regulator again when performing the reverse operating after closing the window fully by
AUTO UP operation.
27. INSPECT POWER WINDOW FUNCTION(See page 70–1)
28. INSTALL FRONT DOOR SERVICE HOLE COVER LH
(a) Install a new service hole cover to the door panel.
HINT:
 When installing the service hole cover, pull out the links
and connectors through the service hole cover.
 There should be no wrinkles or folds on the service hole
cover after attaching it.
 After attaching the service hole cover, sealing condition
should be confirmed.