Toyota 2002 Camry - Out Side Moulding Replacement

760BQ–03
B56187
Protective Tape
B56188
Front Door Outside Moulding
Rear Door Outside Moulding
Adhesive Tape
–EXTERIOR/INTERIOR TRIM OUT SIDE MOULDING
76–13
2716Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
OUT SIDE MOULDING
REPLACEMENT
HINT:
 Installation is in the reverse order of the removal. But, the installation is indicated only when it has a
point.
 In the RH side, work in the same procedure as in the LH side.
1. REMOVE OUT SIDE MOULDING
(a) Using a heat light, heat the body moulding to 40 –
60C
(104 –
140F).
NOTICE:
Do not heat the moulding excessively.
(b) Tie both piano wire ends to wooden block or similar ob-
ject.
(c) Scrape the adhesive tape off by pulling the piano wire as
shown
in the illustration.
NOTICE:
 If reusing the moulding, take care not to damage the
moulding.
 Do not damage the body.
2. INSTALL OUT SIDE MOULDING
(a) Using a heat light, heat the body mounting surface to 40 – 60C (104 – 140F).
NOTICE:
Do not heat the body excessively.
(b) Remove the protective tape from the body.
(c) Wipe off the stains with cleaner.
(d) Clean the moulding (if reusing the moulding).
(1) Using a heat light, heat the body moulding to 20 – 30C (68 – 86F).
NOTICE:
Do not heat the body excessively.
(2) Remove the adhesive tape from the moulding.
(3) Wipe off the stains with cleaner.
(4) Apply new adhesive tape to the moulding as shown in the illustration.