1109H–01
A52585
O–ring
Fuel Pump Tube
Clip
O–ring
Fuel Suction Plate
Fuel Tube Joint
A52589
A52586
–FUEL FUEL PUMP ASSY (1MZ–FE)
11–39
1483Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
Removal & Installation and Disassembly & Reassembly
1. REMOVE REAR SEAT CUSHION PAD
2. REMOVE REAR FLOOR SERVICE HOLE COVER
(a) Remove the service hole cover.
(b) Disconnect the fuel pump connector.
3. WORK FOR PREVENTING GASOLINE FROM SPILLING OUT (See page 11–26)
4. DISCONNECT FUEL PUMP TUBE SUB–ASSY
(a) Check if there is any dirt like mud around the connector
before this work and clean dirt away.
(b) Remove the joint clip, and pull out the fuel pump tube.
NOTICE:
Be careful of dirt like mud because the quick connec-
tor has an O–ring to seal the pipe and the connector.
Do not use any tool in this work.
Do not bend or twist the nylon tube by force.
Keep off plug from foreign objects.
To protect the fuel tube, cover it with a vinyl bag after
checking.
5. REMOVE FUEL TANK VENT TUBE SET PLATE
(a) Remove the 8 bolts and fuel tank vent tube set plate.
6. REMOVE FUEL SUCTION TUBE ASSY W/ PUMP & GAGE
(a) Pull out the fuel suction tube w/pump & gage from the fuel tank.
NOTICE:
Do not damage the fuel pump filter.
Be careful that the arm of the sender gauge should not bent.
(b) Remove the fuel suction tube gasket.
7. REMOVE FUEL SUCTION SUPPORT NO.2
(a) Using a screwdriver, disconnect the snap claws from the claw holes and remove the fuel suction sup-
port No.2.
To Next Page
Loading...
