Toyota 2002 Camry - Ventilation Valve Sub-Assy; Fuel Tank Cap Assy; Emission Control Valve Set

A59511
Cylinder Head Side
Clean Hose
A59512
Intake Manifold Side
A62233
Gasket
A59514
E
F
Continuity
Ohmmeter
A59515
No Continuity
Ohmmeter
12–18
–EMISSION CONTROL EMISSION CONTROL SYSTEM (1MZ–FE)
1511Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
2. VENTILATION VALVE SUB–ASSY
(a) Install clean hose to the PCV valve.
(b) Inspect the PCV valve operation.
(1) Blow air into the cylinder head side, and check that
air passes through easily.
CAUTION:
Do not suck air through the valve. Petroleum substances
inside the valve air harmful.
(2) Blow air into the intake manifold side, and check
that air passes through with difficulty.
If operation is not as specified, replace the PCV valve.
(c) Remove clean hose from the PCV valve.
3. FUEL TANK CAP ASSY
(a) Visually check if cap and/or gasket are deformed or dam-
aged.
If necessary, repair or replace the cap.
4. EMISSION CONTROL VALVE SET
(a) Inspect VSV for EVAP.
(1) Using an ohmmeter, check that there is continuity
between the terminals.
Resistance: 27 – 33 Ω at 20C (68F)
If there is no continuity, replace the VSV set.
(2) Using an ohmmeter, check that there is no continu-
ity between each terminal and the body.
If there is continuity, replace the VSV set.