Toyota 2002 Camry - Page 281

Turn
Pin
Hook
Disconnect
A52463
Push
Plunger
Turn
A52464
Seal Packing
A53051
Nut
Nut
A61989
–ENGINE MECHANICAL VALVE CLEARANCE (2AZ–FE)
14–13–2
1537Author: Date:
(3) Turn the crankshaft counterclockwise, and discon-
nect the plunger knock pin from the hook.
(4) Turn the crankshaft clockwise, and check that the
slipper is pushed by the plunger.
12. INSTALL CYLINDER HEAD COVER SUB–ASSY
(a) Remove any old packing (FIPG) material.
(b) Apply seal packing to 2 locations as shown in the illustra-
tion.
Seal packing: Part No. 08826–00080 or equivalent
NOTICE:
 Remove any oil the contact surface.
 Install the cylinder head cover within 5 minutes after
applying seal packing.
 Do not put into engine oil 2 hours after installing.
(c) Install the cylinder head cover with the 8 bolts and 2 nuts.
Torque: 11 N⋅m (110 kgf⋅cm, 8 ft⋅lbf)
13. INSTALL IGNITION COIL ASSY
Torque: 9.0 N⋅m (92 kgf⋅cm, 80 in.⋅lbf)
14. INSTALL FRONT WHEEL RH
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
15. INSPECT OIL LEAK