Cut Position
A53052
SST
A32658
SST
A32665
A62061
SST
1
2
7
8
3
4
5
6
A61988
–ENGINE MECHANICAL ENGINE REAR OIL SEAL (2AZ–FE)
14–105
1629Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
7. REMOVE ENGINE REAR OIL SEAL
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver with taping its tip, pry out the oil seal.
HINT:
After the removal, check if the crankshaft is not damaged.
If there is, mend it with a sandpaper (#400).
8. INSTALL ENGINE REAR OIL SEAL
(a) Apply MP grease to a new oil seal lip.
NOTICE:
Keep the lip off foreign materials.
(b) Using SST and a hammer, tap in the oil seal until its sur-
face is flush with the rear oil seal retainer edge.
SST 09223–15030, 09950–70010 (09951–07100)
NOTICE:
Wipe off extra grease on the crankshaft.
9. INSTALL DRIVE PLATE & RING GEAR SUB–ASSY(A/T
TRANSAXLE)
(a) Fix the crankshaft with SST (TMC made).
SST 09213–54015 (91651–60855), 09330–00021
(b) Fix the crankshaft with SST (TMMK made).
SST 09960–10010 (09962–01000, 09963–01000)
(c) Clean the bolt and the bolt hole.
(d) Apply Adhesive to 2 or 3 threads of the bolt end.
Adhesive :
Part No. 08833–00070, THREE BOND or equivalent
(e) Install and uniformly tighten the 8 bolts, in several passes,
in the sequence shown.
Torque: 98 N⋅m (1,000 kgf⋅cm, 72 ft⋅lbf)
To Next Page
Loading...
