Toyota 2002 Camry - Inspect Connecting Rod Bolt; Inspect Crankshaft

Z00065
A01470
A13491
A36653
14–126
–ENGINE MECHANICAL CYLINDER BLOCK (2AZ–FE)
1650Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(1) Check for twist.
Maximum twist:
0.15 mm (0.0059 in.) per 100 mm (3.94 in.)
(c) If twist is greater than maximum, replace the connecting
rod assembly.
22. INSPECT CONNECTING ROD BOLT
(a) Using a vernier calipers, measure the tension portion di-
ameter of the bolt.
Standard diameter: 7.2 – 7.3 mm (0.283 – 0.287 in.)
Minimum diameter: 7.0 mm (0.276 in.)
(b) If the diameter is less than minimum, replace the bolt.
23. INSPECT CRANKSHAFT
(a) Using a dial indicator and V–blocks, measure the circle
runout, as shown in the illustration.
Maximum circle runout: 0.03 mm (0.0012 in.)
(b) Using a micrometer, measure the diameter of each main
journal.
Diameter: 54.988 – 55.000 (2.1648 – 2.06535 in.)
(c) Check each main journal for taper and out–of–round as
shown.
Maximum taper and out –of– round:
0.003 mm (0.0001 in.)
HINT:
Mark mm (in.)
0 54.998 – 55.000 (2.16528 – 2.16535)
1 54.996 – 54.998 (2.16520 – 2.16528)
2 54.994 – 54.996 (2.16512 – 2.16520)
3 54.992 – 54.994 (2.16504 – 2.16512)
4 54.990 – 54.992 (2.16496 – 2.16504)
5 54.988 – 54.990 (2.16490 – 2.16496)