90
Engine Front
Paint
Mark
A50671
A36658
No. 1
No. 2
No. 3
No. 4
No. 5
Number Mark
Number Mark
A13475
–ENGINE MECHANICAL CYLINDER BLOCK (2AZ–FE)
14–129
1653Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(j) Mark the front of the bearing cap bolts with paint.
(k) Retighten the bearing cap bolts by 90 in the numerical
order shown.
(l) Check that the painted mark is now at a 90 angle to the
front.
NOTICE:
Do not turn the crankshaft.
(m) Remove the bearing cap.
(n) Measure the plastigage at its widest point.
Standard oil clearance:
0.017 – 0.040 mm (0.0007 – 0.0016 in.)
Maximum oil clearance: 0.07 mm (0.0028 in.)
NOTICE:
Completely remove the plastigage.
(o) If using a standard bearing, replace it with one having the
same number. If the number of the bearing cannot be de-
termined, select the correct bearing by adding together
the numbers imprinted on the cylinder block and crank-
shaft, then selecting the bearing with the same number as
the total. There are 4 sizes of standard bearings, marked
”1”, ”2”, ”3” and ”4” accordingly.
Cylinder block
(A)
+
Crankshaft (B)
0 – 2 3 – 5 6 – 8 9 – 11
Use bearing ”1” ”2” ”3” ”4”
HINT:
EXAMPLE
Cylinder block ”4” (A) + Crankshaft ”3” (B) =
Total number 7 (Use bearing ”3”)
To Next Page
Loading...
