Toyota 2002 Camry - Page 511

C83022
F40147
F40136
F40152
–DRIVE SHAFT / PROPELLER SHAFT FRONT DRIVE SHAFT
30–19
1973Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(b) Install a new cotter pin.
NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further to 60.
46. INSTALL SPEED SENSOR FRONT LH(W/ ABS)
(a) Install the sensor wire and front flexible hose No.1 to
shock absorber with the bolt.
Torque: 18.8 N⋅m (192 kgf⋅cm, 14 ft⋅lbf)
(b) Install the sensor wire clamp.
(c) Install the speed sensor front LH to the steering knuckle
LH with the bolt.
Torque: 8.0 N⋅m (82 kgf⋅cm, 71 in.⋅lbf)
NOTICE:
 Be careful not to damage the speed sensor.
 Prevent foreign matter from being attached.
 Do not twist the sensor wire when installing the sen-
sor.
47. INSTALL FRONT STABILIZER LINK ASSY LH
(a) Install the front stabilizer link assy LH with the nut.
Torque: 74 N⋅m (755 kgf⋅cm, 55 ft⋅lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the stud.
48. INSTALL FRONT AXLE HUB LH NUT
(a) Install a new front axle hub LH nut.
Torque: 294 N⋅m (2,998 kgf⋅cm, 217 ft⋅lbf)
(b) Using chisel and hammer, stake the front axle hub LH nut.
49. INSTALL FRONT WHEEL
50. ADD AUTOMATIC TRANSAXLE FLUID(A/T TRANSAXLE)(See page 40–1)
51. INSPECT AUTOMATIC TRANSAXLE FLUID(A/T TRANSAXLE)
52. ADD MANUAL TRANSAXLE OIL(M/T TRANSAXLE)
53. INSPECT MANUAL TRANSAXLE OIL(M/T TRANSAXLE)