Toyota 2002 Camry - Page 521

C83035
C83015
C83016
–DRIVE SHAFT / PROPELLER SHAFT REAR AXLE HUB & BEARING ASSY LH
30–29
1983Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
7. REMOVE SKID CONTROL SENSOR(W/ ABS)
(See page 32–58)
8. INSTALL SKID CONTROL SENSOR(W/ ABS)
(See page 32–58)
9. INSTALL REAR AXLE HUB & BEARING ASSY LH
(a) Install the rear axle hub LH & bearing assy LH with the 4
bolts.
Torque: 80 N⋅m (816 kgf⋅cm, 59 ft⋅lbf)
10. INSTALL SKID CONTROL SENSOR WIRE(W/ ABS)
11. INSPECT BEARING BACKLASH
(a) Set a dial indicator near the center of the axle hub and
check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
If the backlash exceeds the maximum, replace the axle hub as-
sembly.
12. INSPECT AXLE HUB DEVIATION
(a) Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 in.)
If the backlash exceeds the maximum, replace the axle hub as-
sembly.
13. INSTALL REAR DISC(DISC REAR BRAKE TYPE)