F40319
F40320
BR5332
BR0828
33-22
-PARKING BRAKE PARKING BRAKE ASSY
2073Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
8. REMOVE PARKING BRAKE SHOE
(a) Release the cup claw and remove the front and rear park-
ing brake shoe.
(b) Disconnect the parking brake cable from the shoe lever.
(c) Remove the tension spring and shoe adjuster screw set
from the front and rear shoe.
(d) Remove the 2 shoe hold-down springs, 4 cups and 2
pins.
(e) Using a screw driver, remove the C-washer.
(f) Remove the shim and shoe lever from the parking brake
shoe.
9. INSPECT PARKING BRAKE SHOE LINING
THICKNESS
(a) Using a ruler, measure the thickness of the shoe lining.
Standard thickness: 2.0 mm (0.079 in.)
Minimum thickness: 1.0 mm (0.039 in.)
If the lining thickness is at the minimum thickness or less, or if
there is severe, uneven wear, replace the brake shoe.
10. INSPECT BRAKE DISC AND PARKING BRAKE SHOE
LINING FOR PROPER CONTACT
(a) Apply chalk to the inside surface of the disc, then grind
down the brake shoe lining to fit.
If the contact between the brake disc and the shoe lining is im-
proper, repair it using a brake shoe grinder or replace the brake
shoe assembly.
11. APPLICATION HIGH TEMPERATURE GREASE
(a) Apply the high temperature grease to the shoe attached surface of backing plate.
To Next Page
Loading...
