Toyota 2002 Camry - Page 852

F41523
F41570
F41595
Matchmarks
C92274
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
51–47
2314Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
63. INSTALL FRONT STABILIZER BRACKET NO.1 LH
(a) Install the front stabilizer bracket No. 1 LH with the 2 bolts.
Torque: 19 N⋅m (194 kgf⋅cm, 14 ft⋅lbf)
64. INSTALL FRONT STABILIZER BRACKET NO.1 RH
HINT:
Install the RH side by the same procedures with LH side.
65. CONNECT FRONT STABILIZER LINK ASSY LH
(a) Connect the stabilizer link assy LH to the stabilizer bar
with the nut.
Torque: 74 N⋅m (755 kgf⋅cm, 55 ft⋅lbf)
HINT:
If the ball joint turns together with the nut, use a hexagon
wrench (6 mm) to hold the stud.
66. CONNECT FRONT STABILIZER LINK ASSY RH
HINT:
Connect the RH side by the same procedures with LH side.
67. CONNECT STEERING INTERMEDIATE SHAFT
SUB–ASSY
(a) Align the matchmarks on the intermediate shaft sub–assy
and rack & pinion power steering gear assy.
(b) Install the bolt.
Torque: 35.3 N⋅m (360 kgf⋅cm, 26 ft⋅lbf)
(c) Tighten the bolt.
Torque: 35.3 N⋅m (360 kgf⋅cm, 26 ft⋅lbf)
(d) Install the steering column hole cover No.2 to the steering
hole cover No.1.
(e) Connect the clamp to the steering column hole cover
No.1 and tighten the bolt.