Toyota 2002 Camry - Page 853

51–48
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
2315Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
68. CONNECT TIE ROD ASSY LH
(a) Connect the tie rod assy LH with the nut.
Torque: 49 N⋅m (500 kgf⋅cm, 36 ft⋅lbf)
(b) Install a new cotter pin.
NOTICE:
If the holes for a new cotter pin are not aligned, tighten the nut further up 60.
69. CONNECT TIE ROD ASSY RH
HINT:
Connect the RH side by the same procedures with LH side.
70. INSTALL FRONT WHEEL
Torque: 103 N⋅m (1,050 kgf⋅cm, 76 ft⋅lbf)
71. ADD POWER STEERING FLUID
72. BLEED POWER STEERING FLUID
73. CHECK POWERSTEERING FLUID LEAKAGE
74. INSTALL SPIRAL CABLE SUB–ASSY
(See page 50–9, 50–22)
75. CENTER SPIRAL CABLE(See page 50–9, 50–22)
76. INSTALL STEERING WHEEL ASSY
(See page 50–9, 50–22)
77. INSTALL HORN BUTTON ASSY
(See page 50–9, 50–22)
78. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT(See page 26–5)
79. INSPECT STEERING WHEEL CENTER POINT
80. INSPECT SRS WARNING LIGHT(See page 05–690)