E57145
E57140
–HEATER & AIR CONDITIONER COOLER COMPRESSOR ASSY (2AZ–FE)
55–61
2376Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
11. INSPECT COMPRESSOR OIL
(a) When replacing the compressor and magnetic clutch with new one, after gradually removing the refrig-
erant gas from the service valve, drain the following amount of oil from the new compressor and mag-
netic clutch before installation.
Standard:
(Oil capacity inside new compressor and magnetic clutch: 120 + 15 cc (4.1 + 0.51 fl.oz.) ) – (Re-
maining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be re-
moved when replacing)
NOTICE:
When checking the compressor oil level, observe the precautions on the cooler removal/instal-
lation.
Because compressor oil remains in the pipes of the vehicle, if a new compressor and magnetic
clutch is installed without removing some oil inside, the oil amount becomes too much, pre-
venting heat exchange in the refrigerant cycle and causing refrigerant failure.
If the remaining oil in the removed compressor and magnetic clutch is too small in volume,
check for oil leakage.
Be sure to use ND–OIL8 for compressor oil.
12. TEMPORARY TIGHTEN COMPRESSOR AND
MAGNETIC CLUTCH
(a) Temporarily the compressor and magnetic clutch with the
3 bolts.
13. FULLY TIGHTEN COMPRESSOR AND MAGNETIC
CLUTCH
(a) Using a torque socket wrench (E8), install the bolt.
Torque: 25 N⋅m (250 kgf⋅cm, 18 ft⋅lbf)
(b) Tighten the compressor and magnetic clutch with the 3
bolts and nut.
Torque: 25 N⋅m (250 kgf⋅cm, 18 ft⋅lbf)
(c) Connect the connector.
NOTICE:
Tighten the bolts and nuts in following order shown in the
illustration to install the compressor magnetic clutch.
14. INSTALL COOLER REFRIGERANT SUCTION HOSE
NO.1
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to the new O–ring and
fit surface of the compressor and magnetic clutch.
Compressor oil: ND–OIL 8 or equivalent
(c) Install a O–ring to the cooler refrigerant suction hose No.
1.
To Next Page
Loading...
