Toyota 2002 Camry - Air Bag Sensor Rear LH Replacement

6007Z–01
C92096
–SUPPLEMENTAL RESTRAINT SYSTEM AIR BAG SENSOR REAR LH
60–65
2448Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
REPLACEMENT
HINT:
COMPNENTS: See page 60–64
1. PRECAUTION(See page 60–1)
2. DISCONNECT BATTERY NEGATIVE TERMINAL(See page 60–1)
3. REMOVE CUSHION ASSY, RR SEAT(See page 72–34)
4. REMOVE REAR SIDE SEAT BACK ASSY LH
(See page 72–34)
5. REMOVE AIR BAG SENSOR REAR LH
(a) Disconnect the connector of the airbag sensor rear LH.
(b) Remove the 2 bolts and the airbag sensor rear LH.
6. INSTALL AIR BAG SENSOR REAR LH
(a) Select a suitable bolt (See page 60–1).
(b) Install the airbag sensor rear LH with the 2 bolts.
Torque:
Property class 6T: 17.5 N⋅m (178 kgf⋅cm, 13 ft⋅lbf)
Property class 8T: 20 N⋅m (200 kgf⋅cm, 14 ft⋅lbf)
(c) Connect the connector of the airbag sensor rear LH.
NOTICE:
 Installation of the connector is done with the sensor assembly installed. Make sure the sensor
assembly is installed with the specified torque.
 If the sensor assembly has been dropped, or there are cracks, dents or other defects in the
case, bracket or connector, replace the sensor assembly with a new one.
 When installing the sensor assembly, take care that the SRS wiring does not interfere with other
parts and is not pinched between other parts.
 After installation, shake the sensor assembly to check that there is no looseness.
7. INSPECT AIR BAG SENSOR REAR LH
(See page 60–9)
8. INSTALL REAR SIDE SEAT BACK ASSY LH
(See page 72–34)
9. INSPECT SRS WARNING LIGHT(See page 05–690)