Toyota 2002 Sequoia - CHILD RESTRAINT SYSTEM INSTALLATION; Type A-; Type B-

02_SEQUOIA_U (L/O 0108)
100
2002 MY SEQUOIA_U (OM34418U)
Cap
Covers
Type B
CHILD RESTRAINT SYSTEM
INSTALLATION
Type A —
1. Turn up the covers for left lower
anchorage on the center position of
the seats anchorages on the left side
position of the seats, and remove
the cap for the right lower anchor-
age of the center position of the
seat as shown in the illustration.
2. Widen the clearance between the
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag and cap
in the seat cushion.
3. Latch the hooks of lower straps onto
the anchorages and tighten the lower
straps.
Type B —
1. Turn up the covers for left lower
anchorage on the center position of
the seats anchorages on the left side
of the position of the seat, and re-
move the cap for the right lower an-
chorage of the center position of the
seat as shown in the illustration.
2. Widen the clearance between the
seat cushion and seatback a little
and confirm the position of the low-
er anchorages below the tag in the
seat cushion.
3. Latch the buckles onto the anchor-
ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see “—Using
a top strap” on page 95 in this section.)
For the installation details, refer to the
instruction manual equipped with each
product.