’04Camry_U (L/O 0307)
283
2004 CAMRY from Jul. ’03 Prod. (OM33616U)
When the level reaches within the correct
range, install the filler cap hand−tight.
Oil quantity, L (qt., lmp. qt.):
2AZ−FE engine 1.0 (1.1, 0.9)
1MZ−FE and 3MZ−FE engines
1.5 (1.6, 1.3)
NOTICE
z Be careful not to spill the engine
oil on the vehicle components.
z Avoid overfilling, or the engine
could be damaged.
z Check the oil level on the dipstick
once again after adding the oil.
ENGINE OIL SELECTION
“Toyota Genuine Motor Oil” is filled in
your Toyota vehicle. Use Toyota approved
“Toyota Genuine Motor Oil” or equivalent
to satisfy the following grade and
viscosity.
Oil grade:
API grade SL “Energy−Conserving” or
ILSAC multigrade engine oil
Recommended viscosity:
SAE 5W−30
Outside temperature
SAE 5W−30 is the best choice for good
fuel economy and good starting in cold
weather.
If SAE 5W−30 is not available, SAE
10W−30 may be used. However, it
should be replaced with SAE 5W−30 at
the next oil change.
API service symbol
ILSAC certification mark
To Next Page
Loading...
