’04 HIGHLANDER_U (L/O 0308)
394
2004 HIGHLANDER from Aug. ’03 Prod. (OM48478U)
2. Pull the bulb out of the bulb base
and install a new bulb.
If the connector is tight, wiggle it.
3. Insert the bulb base into the mount-
ing hole by turning it clockwise.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
If any of the following lights burns out,
contact your Toyota dealer.
D Front fog lights
D Front turn signals/parking and front
side marker lights
D Rear side marker lights
NOTICE
Do not try to replace any of the light
bulbs mentioned above by yourself.
You may damage the vehicle.
—Front fog, front turn signal/
parking and front side marker,
and rear side marker lights
To Next Page
Loading...
