Toyota 2004 Matrix - Page 129

’04 MATRIX_U (L/O 0307)
121
2004 MATRIX from Oct. ’03 Prod. (OM12861U)
1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button:
1. Tune in the desired station. (See
“TUNE” or “SEEK” “SCAN”.)
If you desire to select the equalization
that best suits the type of station se-
lected. (See “EQ”.)
2. Push and hold the preset button until
you hear a beep—this will set the sta-
tion and EQ setting to the button. The
preset number will appear on the dis-
play.
3. Repeat the above steps for each but-
ton.
To tune to a preset station: Push the but-
ton for the station you want. The button
number and station frequency will appear
on the display.
RDS stations will be preset to the buttons
when any of RDS stations is received in
the FM mode.
To preset a program type to a button:
1. Push the “AM/FM” button to select
“FM1” or “FM2”.
2. Push “PROG TYPE” button to activate
the program type mode. “P−TYPE” will
appear on the display.
3. Turn the select knob to select the de-
sired program type.
4. Push and hold the preset button until
you hear a beep—this will set the pro-
gram type to the preset button.
5. Repeat the above steps for each but-
ton.
To tune to a station with a desired pro-
gram type: While in a program type mode,
push the preset button for the program
type you want. The program type will ap-
pear on the display and the radio will tune
the station with strongest signal and the
desired program type.
Each button can store one AM and two
FM stations, and two RDS program types.
(The display will show “AM”, “FM1” or
“FM2” when you push the “AM/FM” but-
ton.)
(Eject button)
Push the cassette tape eject button to
eject a cassette. Push the compact disc
eject button to eject a compact disc.
Compact disc player only—If the disc is
not removed after 25 seconds, the disc
will be automatically pulled back into the
receiver.
(Program)
Push the “
” button to select the other
side of a cassette tape. The display indi-
cates which side is currently selected
(“
” indicates top side, “ ” indicates
bottom side).
Auto−reverse feature: After the cassette
player reaches the end of a tape side, it
automatically reverses and begins to play
the other side. This is true whether the
cassette was playing or fast forwarding.
/ (Reverse/Fast forward buttons)
Cassette player
Push the “ ” button to fast forward a
cassette tape. “FWD >>” will appear on
the display. Push the “
” button to re-
wind a tape. “REV <<” will appear on the
display.