Toyota 2004 Sequoia - Page 197

04_SEQUOIA_U (L/O 0309)
189
2004 SEQUOIA from Sep. ’03 Prod. (OM34423U)
Replace the battery by using the following
procedures:
1. Pull the case out while pushing the
lock release button to the side.
2. Remove the discharged battery.
3. Put in a new battery with the positive
(+) side up.
Put in the case securely.
NOTICE
! Make sure that the positive side of
the controller battery is facing cor-
rectly.
! Do not replace the battery with wet
hands. Water may cause rust.
! Do not touch or move any compo-
nents inside of the controller, or it
may interfere with proper operation.
! Be careful not to bend the electrode
of the controller battery insertion
and that dust or oil does not ad-
here to the transmitter case.
! Close the battery case securely.
After replacing the battery, check that the
controller operates properly. If the control-
ler still does not operate properly, contact
your Toyota dealer.