Toyota 2004 Sequoia - Page 25

04_SEQUOIA_U (L/O 0309)
17
2004 SEQUOIA from Sep. ’03 Prod. (OM34423U)
SETTING FUNCTIONS
You can set the following functions by
yourself.
To set the mode 1 (the automatic lock-
ing operation linked to shift lever posi-
tion):
1. Set the parking brake, close all doors
and turn the ignition switch to the “ON”
position.
2. Shift the selector lever into the “P”
position.
3. Within 10 seconds of turning the igni-
tion switch to the “ON” position, press
and hold the front of the driver’s side
power door lock switch for 5 seconds
and then release it.
4. The doors will be locked and unlocked
to indicate that the function is set.
To cancel the function, do the above op-
eration again.
To set the mode 2 (the automatic lock-
ing operation linked to vehicle speed):
1. Set the parking brake, close all doors
and turn the ignition switch to the “ON”
position.
2. Shift the selector lever from the “P”
into the “N” position.
3. Within 10 seconds of turning the igni-
tion switch to the “ON” position, press
and hold the front of the driver’s side
power door lock switch for 5 seconds
and then release it.
4. The doors will be locked and unlocked
to indicate that the function is set.
To cancel the function, do the above op-
eration again.
To set the mode 3 (the automatic un-
locking operation linked to the ignition
switch):
1. Set the parking brake, close all doors
and turn the ignition switch to the “ON”
position.
2. Shift the selector lever from the “P”
into the “N” position.
3. Within 10 seconds of turning the igni-
tion switch to the “ON” position, press
and hold the rear of the driver’s side
power door lock switch for 5 seconds
and then release it.
4. The doors will be locked and unlocked
to indicate that the function is set.
To cancel the function, do the above op-
eration again.
To set the mode 4 (the automatic un-
locking operation linked to shift lever
position):
1. Set the parking brake, close all doors
and turn the ignition switch to the “ON”
position.
2. Shift the selector lever into the “P”
position.
3. Within 10 seconds of turning the igni-
tion switch to the “ON” position, press
and hold the rear of the driver’s side
power door lock switch for 5 seconds
and then release it.
4. The doors will be locked and unlocked
to indicate that the function is set.
To cancel the function, do the above op-
eration again.
CAUTION
To prevent an accident, set and can-
cel the function with the parking
brake set securely.