10. REMOVE CONTROL SHIFT LEVER AND DUST BOOT
a. Remove the nut and wave washer.
Torque: 6.4 N.m (65 kgf.cm, 57 in.lbf)
Fig. 26: Removing Control Shift Lever
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Using a pin punch and a hammer, tap out the lever lock pin.
c. Remove the control shift lever and dust boot.
NOTE: At the time of reassembly, refer to the following item.
When fixing the lever lock pin, properly position the shaft groove.
NOTE: At the time of reassembly, refer to the following items.
Install the dust boot into a groove in the control shift lever.
Be sure to install the dust boot in the correct direction.
2005 Toyota RAV4
2005 TRANSMISSION Manual Transaxle - RAV4
Microsoft
Tuesday, July 21, 2009 9:47:22 AM Page 31 © 2005 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
