Toyota 2005 RAV4 - Page 40

Fig. 35: Removing Clutch Hub With Synchronizer Ring & 5th Gear
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
20. REMOVE NEEDLE ROLLER BEARINGS
21. REMOVE REAR BEARING RETAINER
Using a Torx(R) socket wrench (T45), remove the 7 Torx(R) screws and rear bearing retainer.
Sealant:
Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
22. REMOVE SNAP RING
a. Using a snap ring expander, remove the input shaft rear bearing snap ring.
b
.Usin
g
2 screwdrivers and a hammer, remove the 2 snap rin
g
s.
2005 Toyota RAV4
2005 TRANSMISSION Manual Transaxle - RAV4
Microsoft
Tuesday, July 21, 2009 9:47:23 AM Page 40 © 2005 Mitchell Repair Information Company, LLC.