Toyota 2005 RAV4 - Page 57

Fi
g
. 51: Turnin
g
S
y
nchronizer Rin
g
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c. Using a feeler gauge, measure the clearance between the synchronizer ring back and gear spline
end.
Minimum clearance: 0.7 mm (0.028 in.)
If the clearance is less than the minimum, replace the synchronizer ring, and apply a small amount
of the fine lapping compound on gear cone.
Fig. 52: Measuring Clearance Between Synchronizer Ring Back & Gear Spline End
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. INSPECT NO. 3 SHIFT FORK AND HUB SLEEVE CLEARANCE
NOTE: Ensure the fine lapping compound is completely washed off after
rubbing.
2005 Toyota RAV4
2005 TRANSMISSION Manual Transaxle - RAV4
Microsoft
Tuesday, July 21, 2009 9:47:23 AM Page 57 © 2005 Mitchell Repair Information Company, LLC.