EasyManua.ls Logo

Toyota 2006 RAV4 - Section 1-1: Operation of Instruments and Controls; Overview of Instruments and Controls

Toyota 2006 RAV4
393 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
’06 Rav4_U (L/O 0601)
21
2005 RAV4 from Jan. ’06 Prod. (OM42620U)
3. Open and remove the battery case
cover using a coin.
4. Take out the discharged battery and
put in a new battery with the positive
(+) side up.
5. Install the battery case cover and then
install the module into the key frame.
Close the cover.
6. When pushing either switch on the
wireless key, make sure the indicator
light comes on.
NOTICE
Do not bend the terminals.
Make sure the positive side and
negative side of the battery are
faced correctly.
Do not replace the battery with wet
hands. Water may cause unexpected
rust.
Do not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.
Be careful not to bend the electrode
when inserting the battery and that
dust or oils do not adhere to the
battery case.
Close the battery case securely.
After replacing the battery, check that the
key operates properly. If the key still does
not operate properly, contact your Toyota
dealer.

Table of Contents

Other manuals for Toyota 2006 RAV4

Related product manuals