309
2007 4Runner from Aug. ’06 Prod. (OM35866U)
(a) Programming the HomeLink
The HomeLink
in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
HomeLink
, install a new battery in the
hand−held transmitter prior to program-
ming.
The battery side of the hand−held trans-
mitter must be pointed away from the
HomeLink
during the programming pro-
cess.
For Canadian users, follow the procedure
in “Programming an entrance gate/pro-
gramming all devices in the Canadian
market”.
1. Decide which of 3 HomeLink
buttons
you want to program.
CY19131
HomeLink
25 to 75 mm
(1 to 3 in.)
Hand−held
garage
transmitter
2. Place your hand−held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
the surface of the HomeLink
.
Keep the indicator light on the HomeLink
in view while programming.
CY19132
3. Simultaneously press and hold the
hand−held garage transmitter button
along with the selected HomeLink
but-
ton.
Do not release the buttons until step 4
has been completed.
4. When the indicator light on the
HomeLink
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
06 06.07
To Next Page
Loading...
