Toyota 2007 4runner - Page 457

311
2007 4Runner from Aug. ’06 Prod. (OM35866U)
6. Test the operation of the HomeLink

by
pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink

button to program
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
Individual HomeLink

buttons cannot be
erased, however, to reprogram a single
button, follow the procedure “Programming
the HomeLink

”.
(b) Operating the HomeLink

To operate the HomeLink

, press the
appropriate HomeLink

button to activate
the programmed device. The HomeLink

indicator light should come on. The
HomeLink

continues to send the signal
for up to 20 seconds as long as the
button is pressed.
CY19133
(c) Erasing the entire HomeLink

memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink

memory.
For additional programming assistance
with your HomeLink

Universal
Transceiver call the:
 The Toyota Customer Experience
Center at 1−800−331−4331 (U.S.A.)
 Toyota Canada Customer Interaction
Centre at 1−888−869−6828 (Canada)
Refer to HomeLink

on the internet at:
WWW.HOMELINK.COM
06 06.07