138
Automatic control adjuster
To turn on the windshield wipers, move
the lever to the desired setting.
The ignition switch must be set at ON.
Lever position Operation
Position 1 Automatic operation
Position 2 Low speed operation
Position 3 High speed operation
Position 4 Single sweep operation
Position 5 Washer on
Automatic operation (position 1)
The wiper speed is determined by the
amount of raindrops and sunlight detected
by the automatic wiper control sensor.
The automatic wiper control sensor is on
the inside of the windshield as shown
above.
If you feel that the operation of the auto-
matic wiper control is too fast or too slow,
twist the automatic control adjuster in the
“−” direction to lower sensitivity, and “+”
direction to boost the sensitivity.
Even if the wiper lever is in the position
1, the system will switch to intermittent
operations in the following conditions:
When the windshield gets extremely
cold (at less than −10C [14F])
When the system malfunctions
However, when the windshield gets ex-
tremely hot (at more than 90C [194F]),
the wipers do not operate even if the
wiper lever is in the position 1.
As soon as the vehicle starts to move,
the wiper will operate once to clear the
driver’s front view if it is set to “AUTO”.
Windshield wipers and washer
(raindrop detection type)