’07 HIGHLANDER_U (L/O 0608)
398
2007 HIGHLANDER from July ’06 Prod. (OM48682U)
2. Pull the bulb out of the bulb base
and install a new bulb.
If the connector is tight, wiggle it.
3. Insert the bulb base into the mount-
ing hole by turning it clockwise.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.
If any of the following lights burns out,
contact your Toyota dealer.
Front fog lights
Front turn signals/parking and front
side marker lights
Rear side marker lights
NOTICE
Do not try to replace any of the light
bulbs mentioned above by yourself.
You may damage the vehicle.
—Front fog, front turn signal/
parking and front side marker,
and rear side marker lights
To Next Page
Loading...
