EasyManua.ls Logo

Toyota 2007 Sequoia - SECTION 1-5 OPERATION OF INSTRUMENTS AND CONTROLS

Toyota 2007 Sequoia
484 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
135
2007 SEQUOIA from Aug. ’07 Prod. (OM34462U)
2. Turn up the cover for lower anchor-
ages of the right side position. Con-
firm the position of the lower an-
chorages below the button on the
cover.
3. Type A—Latch the hooks of lower
straps onto the anchorages and
tighten the lower straps.
Type BLatch the buckles onto the
anchorages.
For owners in Canada—The symbol on
a child restraint system indicates the pres-
ence of a lower connector system.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see —Using
a top strap (for third seats) on page 126
in this Section.)
For installation details, refer to the instruc-
tion manual equipped with each product.
CAUTION
! When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
! Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
! When using lower anchorages for a
child restraint system on the third
seats, ensure that the seat is
moved to the rearmost position,
with the seatback close to the child
restraint system.
! After securing the child restraint
system, never slide or recline the
seat.
! Do not install a child restraint sys-
tem on the third seat if it interferes
with the lock mechanism of the sec-
ond seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in case of sud-
den braking or a collision.
07 05.22

Table of Contents

Related product manuals